Inside your brand new Sculpfun S9 is an ESP32, Internet of Things (IoT) chip. Right next to it is a tiny antenna connector. Let’s set up the Sculpfun S9 Bluetooth, shall we?
While I don’t think Sculpfun has enabled WiFi in the firmware, the bluetooth is ready to roll and it isn’t that hard to get working.
You basically just need to remove the cover from the motherboard by removing the 4 screws on the back. Once the mainboard is exposed you just need to hook an antenna to it. Bluetooth is 2.4 GHz so basically any wifi antenna with the proper connector will work. Here is what you need to do:
The Sculpfun S9 is a great laser and is available at a fantastic price point. Any time the price is low on something you can bet a bell or a whistle was left out to keep the final cost down. One way to cut corners on a laser is to offer them without limit switches. Without switches, the laser will not automatically return to the home position (X0, Y0). Positioning is accomplished manually. Fortunately there is a Sculpfun S9 Limit Switch kit available for purchase.
There is nothing wrong with a laser that does not have limit switches. In fact, some people prefer lasers that don’t have limit switches. A lot of the time, I am one of those people.
Equally safe to say that there are a lot of people out there who wouldn’t own a laser that didn’t have limit switches. Anyway, with the S9, at least you have the option.
The cost of the kit is $27.99 and is all inclusive. The kit works for both the S9 and the S10 models. There are differences in the installation procedures but the kit contains all the stuff you need to install on either model. That probably means you’ll have some stuff left over in your kit when you are done with the mod.
Sculpfun gave me a Sculpfun S9 for review and I posted my initial impressions about a week ago. After a week of some testing and more usage I can provide a more authoritative opinion on the laser. In a nutshell I find that the S9 is far above average for the price point that it resides in. In my opinion this would make an excellent entry level laser for someone. Or even better, it would make an excellent back up machine for a home business or side hustle.
I read a lot of laser forums. Everyday I read posts like this. “The laser has broken and I have orders to fulfill”. You’d be able to fulfill them if you owned a backup machine.
I was recently contacted by Sculpfun and provided a Sculpfun S9 laser to review.
I have owned multiple desktop lasers since they first became mainstream around 2019. Fast forward 5 years and desktop lasers are gaining in popularity. The laser side hustle is a real phenomenon and seemingly getting stronger all the time. Despite the many choices in desktop lasers, they are all fairly similar.
Most machines contain a 450 nanometer (nm), 5 watt blue laser diode. That is roughly the most powerful diode on the market. Manufacturers who have 10 watt, or 20 watt optical output simply combine multiple diodes into one beam. A 10 watt laser has 2 diodes, and a 20 watt laser has 4 diodes, and so on.
Similarly, most of these devices have a rectangular frame somewhere around 350 to 400 mm in length and width. The laser head is driven by an 8 bit or 32 bit motherboard and stepper motors, and the laser is manually focused.
Since the machines are all so similar, the thing that sets them apart is cost. Many desktop diode laser offerings come in around the $500 price point. Lasers that cost less than that price point are a little tougher to find.
Enter the Sculpfun S9 at the current price of $269.99. And as a bonus, Sculpfun has provided my readers a 7% off discount code. KJKXP7 (S9). By my calculations that makes the laser approximately $251.09. I have done blogs on budget lasers and $250 is an EXCELLENT entry level price point.